In order to install suspended ceilings during construction work or repair, it is necessary to properly mark the space. Using the hydraulicarian, set the zero points in all available angles of the room. After which you determine the lowest angle and in it put the mark below by 3.5 cm. This height is necessary for the subsequent installation of the fastener profile.
Next, you need to measure the distance from this mark to the zero point and put the corresponding tags in each corner of the room. Connect the obtained marks using the coloring threads. So you get the lines of the fastener of the profile. Using special dowels, attach the profile around the perimeter of the entire room along the line marked on the walls. If the walls of the room are erected from drywall, then you will not be able to do with simple dowels. In this case, you will need special mounts. Lay out the profile so that its lower edge clearly lay down on the marked line.
If you plan to install a chandelier in the center of the room, then after attaching all the profiles, prepare a place for it. In the case of fastening the chandelier to the ceiling using a hook or directly nullification of this lighting device to the surface of the ceiling, hide a certain bookmark behind a stretch ceiling. Through it you can lay an electric wire.
If you decide to install spotlights on the ceiling, then such a mortgage will also need to be strengthened. However, in this case, a hole is made in it under the lamp. You can use a plumbing plug on a 110mm pipe, having previously made a hole in it.
Next, the installation of a stretch ceiling itself will begin. If you have chosen the stretch structure of the harpoon system, then its mounts are delivered to the object sealed in the box. After the room warms up to the required temperature (60-70 degrees are optimal), the heat gun is carefully directed towards the bundle and unfolded. Start fastening the canvas in the corner from which. For work, you must need a spatula in the case of a spatling system. If you have opted for the nozzle system. then fastening is performed manually without using any tools.
After you fastened one corner of the canvas, go to the opposite corner. If you have an assistant, then do work in two opposite corners at the same time.
After the canvas was fastened in all four corners, it needs to be fastened in the middle of each wall. Further, the resulting wall gaps are divided in half, at these points the canvas is again fastened. So until the end of the installation of the entire canvas. Thus, the stretch ceiling will be installed qualitatively.
The end of all the work be sure to rub the surface of the ceiling with an alcohol -based tool. Thus, you can avoid dirt and spots remaining on the ceiling after its installation. Now the ceiling is completely ready for operation.