The main information on the construction of the garage for this article is taken on the site . First of all, it should be noted that the garage floor must be arranged in such a way that it does not give cracks and uneven sediments during the load from the car wheels. Floor level (usually cement or concrete) must be made 10 centimeters higher in relation to the surface of the earth. The floor of the floor and blind area should be made taking into account the small slope towards the garage gate. This is done in order to take moisture from the garage room.
Before you engage in the garage floor itself, you must carefully compact the soil under it, and apply a layer of crushed stone 20 centimeters on top. The lower layer of crushed stone is crumpled directly into the ground. For separation of the floor from the walls (so that it is free on the ground), foam, the thickness of which 5cm should be laid along the perimeter of the walls. Then a plastic film is laid, on top of which the reinforcing network is placed (the safety of its protective layer should be at least 4 centimeters), and only then the concrete mixture is laid. After the concrete grabs (within 5-7 days.), a cement-sand screed is made, the thickness of which is 5cm for aligning the floor.
On the perimeter of the garage building from its outer side, a concrete blind area is made, which will help eliminate the possibility of flooding the foundation. 50-70 centimeters will be quite enough for the width of the blind area. In its construction, concrete of the brand in 7 is used.5, which is laid on top of the sand pillow. Ramp, which is a rectangular or curved inclined site for the entry of the vehicle, is made from the main facade. The ramp serves for a more convenient race in the garage room. The width of the ramp should vary from 50 to 120cm, taking into account the relief of this area.