To drill the tiles, in the place where it is supposed to be drilled — beat enamel. This must not be done with all our might, carefully, we hit at a slight angle so as not to be smashed by chance. This action is necessary to guarantee that the drill will not slide along the surface of the tile. The drill will go for such work any. It is possible on a manual drive, you can on electrical. A hole up to 10 mm in size is obtained using a winning tip. If the drill is electric and has an unstressed operation mode, turn on this mode. Do not need to be given to tiles, do not crush that there are no sharp blows. We drill at the lowest speed.
Looking for a good company that leaves money for low interest? We advise you to visit our site http: // Dengi-srochno. info and we borrow money at a low interest and for a good time.
There is such a thing as a conductor. It looks like a stencil. Is a thick plate with holes of different sizes. How to drill, I think it’s not difficult to understand. It is necessary to attach to the tile of the stencil and drill. You can ask to hold a stencil from your family. The plate will serve for a long time, as it is made of steel. If you do not have such a stencil, there is another way. We make a small hole, then carefully and gradually expand it to the desired size. Now you know how to drill ceramic tiles. You can start work. Good luck!