Very often in everyday life, people are faced with the need to make holes in the concrete wall. Concrete can be called a «strong nut», but it can also be conquered by using several practical advice. In the process of drilling, interference may occur, caused by the presence in the wall canvas of metal reinforcement and small pebbles. In order to successfully cope with such obstacles, you need to use the punch. At the same time, the pebbles will break under his blows, and the rods of the reinforcement can easily be drilled using the usual drill. Today, drill a concrete wall is no more difficult than performing the installation of the channel fan, go by the given link and you will find out a lot of useful and interesting information about the channel fan, etc. D.
If during the work the drill, which is used to weld concrete, moisten with water from time to time, then its service life will increase significantly. Some chandeliers must be attached directly to the surface of the ceiling. This causes a certain inconvenience in the master, since construction garbage simply rains abundance in the eyes, behind the collar, into the sleeves. This effect can be avoided using a simple device — a funnel rolled out of the wire, covered with plastic wrap. This design must be put on a perforator or drill immediately before use. And then you can easily avoid clogging of the eyes.
As a funnel, you can also use a rubber ball that is no longer suitable for use for its intended purpose. It needs to be cut in half and done in one of the halves that will be used in the future, the hole into which the playabur will then be inserted.
You can get rid of garbage and dust that remained after making holes with an ordinary vacuum cleaner. It is necessary to use a thick paper bag to collect garbage, so that then it can be thrown away.