To lay the slate, you need to buy: a hammer, ticks, a grinder, slate nails and slate itself, a couple more ropes with hooks. These ropes are needed to pull the slate to the roof. Next, we make a crate and cover with roofing roofing room five to ten centimeters from the roof. But do not forget the length of the slate itself, otherwise you will not be able to nail it. The slate is nailed by nails not ordinary, but slate. This is done so, two nails are driven below and on top of the sheet.
Want to buy a cheaper air conditioner inverter type, but don’t know where? We advise you to visit our site and buy air conditioning at a reasonable price. You will also find a lot of useful information on our site.
Note that they are driven only into the crest of the waves or the material will collapse. There are as many as 2 ways to lay slate sheets. The first type of styling is running. This method does not require you to cut the corner of the slate. The next slate is put on the previous one, so that the joint is opposite to the wind. This method is easier to implement technically, but not financial. The second type of slate laying is a combination method. It is a technically more complex, but more economically profitable option. We cut each angle so that it is completely combined with the edge. You need to nail the slate with slate with slate, which have special boring or screws, because they do not require drilling holes for them. Nail should be beaten with nails, the length of which reaches to the lowest boards. Cut the slate of slate only with a diamond disk.