Emale paints due to the complex composition are produced ready for use. If the paint is stored for a long time, then it will thicken, and it is diluted with special solvents.
Before painting, the working surface is aligned, cleaned of dirt, dust and primed. The primer is necessary for degreasing the surface and good adhesion of the paint with the surface. The primer allows you to save paint economically.
Enamel can be applied with a pistol-sprayer and with small areas with a brush. To apply a thin layer of paint, the hair of the brush is briefly tied, up to about 3-4 cm.
The paint is applied to the wall with separate stripes with small gaps. Then, the enamel is smeared with perpendicular movements of the brush on the surface, and shaken it with the transverse movement of the hand.
To stain concrete plastered surfaces in winter (with an air temperature of not higher than 5 degrees), silicon enamel is used. When staining concrete surfaces, the enamel is applied to 2-3 layers (while each layer is applied to the previous one after 1-2 hours). When stained, the formation of praises, wrinkles and gaps should not be allowed.
Emale paints PF-253, PF-265, FL-264 are used for painting floors in two layers. The floor is aligned before painting, cleaned of garbage, dust and dried the surface at room temperature 18-20 degrees. For painting the floor, a flywheel or roller is used. Corners and skirting boards are painted with fluits.
NC paints (nitroglyphal enamel paints) are used to stain internal, external wooden and metal surfaces. Metal surfaces are cleaned of rust, dust and painted with a brush.
Each person thinks about comfort and comfort in his house. The house where you can relax, walk barefoot on the floor. A pleasant sensation will provide you with a parquet board which you can buy in our online store. Moreover, the range of prices and varieties of parquet boards will pleasantly surprise you.